SkudoBoard is an engineered, lightweight rigid protection board that delivers superior jobsite protection under machinery, forklifts, material carts and heavy foot traffic. It is ideal anywhere Masonite or plywood would normally be used, with added resistance to water, curling and warping.

• Protects against forklifts, carts, ladders, lifts and machinery
• High impact resistance helps spread heavy loads
• Water resistant and slip resistant in wet conditions
• Fire retardant: ASTM E 648 Class 1 / 16 CFR 1630
• Resists curling and warping to reduce jobsite hazards
• Lightweight, easy to handle and reusable
• Protects against spills, stains, mud, dirt, rust and mild solvents

SkudoBoard should not be used on unprepared or uneven ground. It should not be installed directly over freshly placed concrete unless the concrete will later be covered with another finish such as tile, carpet, LVT or another flooring system. Using SkudoBoard on uncured concrete may create visible curing lines at board joints.

Clean the surface before installation. Install boards in a stack bond or running bond layout. Leave approximately 1/16" expansion gap between boards in hot conditions. Tape seams with minimum 3" wide trafficable tape suitable for interior and exterior use.

Prepare the surface by removing dust, dirt and debris. Lock boards into place by pressing down the interlocking tabs. For heavier traffic, taping the tabs is recommended for additional stability.